Notice of Reconstituting and Injecting the Growth Hormone

Notice of Reconstituting and Injecting the Growth Hormone

Use of Water:

Several types of water can be used to reconstituting Human Growth Hormone, including sterile bacteriostatic water (0.9% sodium chloride), normal saline (0.9% NaCl) or plain sterile water for injection.

Use of Syringes:

The insulin type syringes are the most suitable for HGH injection. It's easier to determine the dose of HGH properly if it's possible to get 100 markings syringes on the side.

Steps of mixing HGH(reconstitution):

-Remove the plastic cap of top, clean the rubber with a alcohol pad. -Take an insulin syringe and pull 1-2ml water into it. -Push the needle through the rubber cap of the vial, inject the water along the vial sideways, then the water will slide down the inside wall of the vial. Remember do not inject directly into the powder with force, but let the water slide out slowly. Most of white powder will dissolve in seconds, but there will be some lumps left over. Do not shake the vial to get them to dissolve, you can gently roll the vial between your fingers. If you do this for a few minutes all of the powder will dissolve. Alternatively you can let the vial sit in the refrigerator for 15 – 30 minutes. By that time the somatropin will dissolve completely. -Gently turns the vial to mix the solution, then pull enough liquid HGH into the insulin syringe.